Electrician testing the circuit behind a faulty electric shower

Emergency electrician for heating and showers, Edinburgh

Shower, heating or hot water dead?

Cold and unwashed is no way to wait. We repair electric showers, immersion heaters, storage heaters and other electric heating.

  • ✓ Someone always on the phone
  • ✓ Edinburgh and its neighbouring towns
  • ✓ Hazards isolated, then fixed

Any hourIncluding nights and bank holidays

Hazards dealt with firstRisky faults isolated immediately

Covering EdinburghInside the city and out into the Lothians

Signed off by testingRepairs verified and talked through

Electrician examining a heating circuit at a consumer unit
01 Located. Isolated. Mended.

Electric heating, shower and hot water faults in Edinburgh

When the warmth and hot water stop.

Plenty of flats across Edinburgh depend on electricity for heating and hot water, so a failure bites hardest in the colder months.

Electric showers pull a heavy load, which makes them a frequent source of trips, scorched isolators and burnt terminals. Immersion heaters stop when an element or thermostat burns out, and storage heaters may stop charging because of the timer, the dedicated off-peak feed or the heater itself.

Not every fault is electrical; some need a plumber or heating engineer. We'll say plainly which applies and deal with the electrical part promptly.

Checks you can make →

First steps

Safe checks before calling.

Should a shower unit, isolator or heater smell scorched, look burnt or feel damp, turn it off and leave it alone.

  1. 1

    Find the isolator

    Confirm the pull-cord or wall switch feeding the shower or immersion heater is switched on.

  2. 2

    Look at the breakers

    Check for a tripped breaker or RCD, resetting it once only. Should it drop again, keep it off.

  3. 3

    Review timers and dials

    On immersion and storage heaters, look at the timer, boost control and thermostat.

  4. 4

    Ring us

    When it still refuses to work, or anything is hot or blackened, phone us.

Checked what you can? Ring now.

What we do

Back to warm, back to clean.

We locate the electrical fault, mend or replace the faulty component and test the whole circuit before it goes back into use.

Electric showers

Trips and breakdowns are traced to the unit, isolator, cable or circuit, and the faulty part is repaired or swapped.

Immersion heaters

Elements, thermostats, timers and isolators are tested and renewed where they've failed.

Storage and panel heaters

We inspect off-peak supplies, timers, wiring and controls, and cure faults that stop heaters charging or heating.

Heating, shower and hot water questions

Handy answers first.

My electric shower keeps tripping the power. Why?+

Typically a fault inside the unit, water ingress or a tired cable or terminal. Keep that circuit off and call us to test it.

My immersion heater gives no hot water. What's wrong?+

A dead element or thermostat is likely, though a switched-off timer or isolator would do the same. Check both, then ring us if the water stays cold.

My storage heaters are stone cold. Where do I look?+

Look at the input and output dials and confirm the off-peak timer is running. Still no charge? Call us.

Can you repair a gas boiler?+

No, gas boilers belong to Gas Safe registered engineers. Our work covers electrical faults, which includes the supply to boilers and heating controls.

Elsewhere in the building

Is something different wrong?

Whatever the electrical emergency, we cover Edinburgh. Choose the heading that fits best, or phone and tell us what you're seeing.

See the full list of emergencies →

Not sure what's failed? Phone us to find out.

Get in touch

Let us know what's wrong.

Ring us straight away in an emergency. If it's less urgent, send some details and we'll respond.

Emergency line, always staffed0131 496 0000

Open all hours, all week · Edinburgh and nearby towns

Add photos or documents (optional)No files chosen

Your information is used only to respond to this enquiry.

☎ Ring 24/7: 0131 496 0000